11
NHM/NHP Series NHM/NHPATCE29
5) Adjust the position of the changer arm and the spindle
①
Perform
"Pin Unlocking"
in manual operation.
②
Insert the changer arm fixture (see the figure below) into the changer arm.
③
Push in the center bar to the centering fixture
to check if the changer arm aligns with the
spindle both horizontally and vertically. If they
are misaligned, adjust the secondary reference
point of both X and Y axes until they are
aligned correctly.
※
How to adjust the secondary reference point
①
To allow for the axial feed where the changer arm is positioned in the spindle side, change
"Keep Relay K12,2" to 1.
("When Used Maintenance For ATC")
②
Select Handle mode. Use MPG to feed both X and Y axes. Then, check using the center
bar if the changer arm aligns correctly with the spindle.
③
When done, enter the current machine coordinates (X,Y) in Parameter #1241.
Summary of Contents for NHM Series
Page 1: ...Machine Tools Adjusting Maintaining ATC NHM NHP Series ...
Page 2: ......
