3
NHM/NHP Series NHM/NHPATCE29
2) Install the sub changer fixture
①
Manipulate the magazine manually so
that the tool pot #1 comes to the
changing position.
②
Install the centering fixture between tool pot and sub changer, and move the sub changer
to the pot position of the magazine.
※
If the magazine has the home-position mark
badly misaligned, remove the tool positioning key
in advance. Otherwise, this may cause damage
to the key due to conflicts between sub changer
and fixture while the sub changer is moving to the
pot position of the magazine.
3) Check the home position of the magazine
Push in the center bar to the centering fixture as
shown, and check to see if the changer arm
aligns with the tool pot correctly. If they are
misaligned, refer to "4) Feed the magazine in
JOG mode" below to move the magazine pot
finely.
Sub
Changer
Centering
Fixture
Centering
Fixture
Center Bar
Centering
치구
Move the tool pot #1
Remove the Key
Summary of Contents for NHM Series
Page 1: ...Machine Tools Adjusting Maintaining ATC NHM NHP Series ...
Page 2: ......