1835-067-A-9-18
34
This programming sequence sets which relay(s) will activate when the system receives a
rotary-dial 9 open command
from a
residents rotary telephone. The system can be programmed so that only one relay will activate, or any combination of relays will
activate. TIP: The relay that you designate as the primary relay should be programmed to activate from a rotary 9 command.
Factory setting = 010 (only relay 1 activates)
3.3.6 Rotary-Dial 9 Relay
(
s
)
Activation
1.
Press and enter your four-digit MASTER CODE (
beep
).
2.
Enter the
three-digit
(1's or 0's only)
rotary 9 code
, then press (
beep
).
Three-digit positions:
1st digit position -
Relay 0
, 2nd digit position -
Relay 1
, 3rd digit position -
Relay 2
.
To activate a relay - enter a 1 in a digit position.
To
NOT
activate a relay - enter a 0 in a digit position.
Example: entering 010 will cause only relay 1 to activate. Entering 101 will cause both relay 0 and relay 2 to activate.
3.
Press together to end this programming sequence (
beeeeeep
).
This programming sequence will set the telephone entry system to dial out in either a touch-tone or rotary format. Generally,
this will be set for touch-tone.
Factory setting = touch-tone.
3.3.5 Touch-Tone / Rotary-Dial
1.
Press and enter your four-digit MASTER CODE (
beep
).
2.
Press (
beep
) for
touch-tone
, OR (
beep
) for
Rotary
3.
Press together to end this programming sequence (
beeeeeep
).
0
0
?
?
?
?
?
?
?
?
0
1
1
5
7
0