Donaldson Torit WSO 10, Installation And Operation Manual

Page: 16 / 40

Donaldson Company, Inc.
16
WSO 10, 15 Collector Stand Installation
For applications with limited mounting surfaces, an
adjustable stand is available for the WSO 10 and
15. The stand height may be adjusted up to a
maximum of 117-in from the top of the collector to
the bottom of the stand.
Stand Base Installation, WSO 15 shown
CAUTION!
Donaldson equipment is not designed to
support site-installed ducts,
interconnecting piping, or electrical
services. All ducts, piping, or electrical
services supplied by others must be
adequately supported to prevent severe
personal injury and/or property damage.
CAUTION!
If collector drainage is not properly
maintained, the collector may collapse on
stand and cause severe personal injury
and/or property damage. Maintain proper
collector drainage.
1. Install customer-supplied anchor bolts (Hilti
Kwik Bolt 3 [KB3] 3/8-in diameter x 1.63-in
embedment in uncracked 2,500 psi concrete or
equivalent) in the floor extending 1 ½ inches
above surface. Use anchor bolt pattern from the
stand specification drawing or see anchor bolt
pattern on stand base.
2. Install stand base, level, and securely tighten
anchor bolts. See Stand Base Installation below.
3. Orient the front of the mist collector to face the
forklift. Adjust the forks of the forklift to lift
collector on the cabinet and inlet flange. Secure
unit to the forklift. See Collector on Forklift
detail.
4. Remove the center two inlet hopper bolts from
the back of the unit and install the formed angle
stabilizing bracket using the bolts and washers
removed from the inlet hopper. See Detail A.
5. Remove the two eyebolts on the back of the
collector and attach the upper stand bracket of
the stand to the collector using the provided
8mm bolts and washers. See Detail B.
6. Using the provided hardware 3 1/4-in x 3/8-in
bolts and mounting plate, secure the bottom of
the collector to the stand. See Detail A.
7. Securely fasten all hardware. See Details A and
B.
8. Lift collector and top portion of the stand over
previously installed stand base and lower to the
desired height. See Upper and Lower Stand
Installation detail and Stand Height Adjustment
detail.
9. Securely fasten the clamping hardware for
added safety. See Detail D.
10. Permanently secure the stand height by drilling
a 3/8-in hole through the upper and lower tubes
and securing with a ½-in nut and bolt. See
Detail C.
stand base
anchor bolt
foundation
lower stand