EN
Adjusting the awning
PW3500
20
7
Adjusting the awning
7.1
Resetting the outer limit
The optimum outer limit of the awning is set by default. Over time, the setting
for the outer limit can become incorrect. The awning then fails to extend fully
or far enough so that the fabric hangs down.
Reset the outer limit as follows:
➤
Extend the awning all the way until it stops.
➤
Turn the lower control knob on the motor (fig.
9
1, page 6) anti-clock-
wise to extend the stop limit further.
➤
Turn the lower control knob on the motor (fig.
9
1, page 6) clockwise to
reduce the stop limit inwards.
➤
Retract and extend the awning a little to check the setting.
➤
Repeat the setting if necessary.
7.2
Reprogramming the wind sensor
The wind sensor is set to the receiver and the remote control by default. The
wind sensor must be reprogrammed in the following cases:
z
If the wind sensor no longer responds.
z
If the wind sensor has been replaced.
z
If a new remote has been reprogrammed.
z
After the receiver and remote control have been reset.
Summary of Contents for PerfectWall PW3500
Page 2: ......
Page 3: ...PW3500 3 1 1 2 3 4 5 2 2 1 3 1 4...
Page 4: ...PW3500 4 1 5 1 2 A B C D 1 2 6...
Page 5: ...PW3500 5 7 1 8...
