EN
PW3500
Operating the awning
17
6.5
Changing the battery in the remote control
I
➤
Open the housing of the remote control (fig.
3
1, page 3).
➤
Remove the old battery from the holder.
➤
Insert the new CR2450 (3 V) battery type into the holder with the positive
terminal facing upwards.
➤
Reassemble the remote control.
B
Protect the environment!
Do not dispose of any batteries with general household waste.
Return defective or used batteries to your retailer or dispose of
them at collection points.
6.6
Changing the batteries in the wind sensor
I
➤
Extend the awning if required.
➤
Move the wind sensor (fig.
5
1, page 4) on the inside of the front cover
to the left and take it off.
➤
Release the sensor insert (fig.
6
A, page 4).
➤
Remove the sensor insert from the housing (fig.
6
B, page 4).
I
➤
Replace the used batteries with new AAA or LR03 (1.5 V) alkaline
batteries (fig.
6
C, page 4). Make sure the polarity is correct.
NOTE
If the LED in the remote control does
not
light up after pressing
one of the buttons, the remote control battery is flat.
NOTE
When the batteries of the wind sensor are running low, the wind
sensor indicates this with a brief beep tone which is repeated
every 5 seconds.
The awning also retracts automatically after 30 minutes, even if it
is not windy.
NOTE
Do not use rechargeable batteries.
Summary of Contents for PerfectWall PW3500
Page 2: ......
Page 3: ...PW3500 3 1 1 2 3 4 5 2 2 1 3 1 4...
Page 4: ...PW3500 4 1 5 1 2 A B C D 1 2 6...
Page 5: ...PW3500 5 7 1 8...
