BR342 Ducted Installation Instructions
Installing the Unit
•
Hold the ceiling template up to the roof opening. Make sure the large plate faces
the rear of the RV. See FIG. 10.
•
Start each mounting bolt through the ceiling template and up into the unit base
pan by hand. Install wood screw in each end of the ceiling template. This
ensures a tight fit of the return air cover to ceiling. See FIG. 10.
15
FIG. 10
NOTICE!
Tighten mounting bolts to correct torque specifications. Overtightening
could damage unit’s base pan or
ceiling template. Not enough torque
will allow an inadequate roof seal, and could cause a leak.
•
Tighten all four (4) mounting bolts EVENLY to 4.5 to 5.5 Nm. See FIG.10
•
Measure the ceiling to roof thickness:
−
If distance is 50.8
–
95.25mm, remove perforated tab from divider plate. See FIG. 11.
−
If distance is 95.25
–
139.7mm, remove no tabs.
•
Remove the backing paper from double-sided tape located on ceiling template.
See FIG. 11.
FIG. 11
Tighten to
4.5 to
5.5Nm
50.8
–
95.25mm
