BR342 Ducted Installation Instructions
Installing the Unit
17
•
Excess width is intended to seal the divider plate to the sides of the roof opening. This is to help prevent cold air
discharge from circulating into the unit return air opening.
•
If the insulation is too high, stick excess height of the insulation to the unit base pan. Do not cover up unit rating plate.
Wiring Connections
•
Fix the return air sensor so it is position in the return air stream.
•
Connect the communication wire to the wire from the electronic wall control (also refer to instructions provided with the
wall control).
•
Make connections for the 240VAC positive (+), negative (-) and earth from the supply to the rooftop unit and ensure they
are well insulated.
•
Tuck any excess wire up out of the way.
WARNING!
Electrical Shock Hazard:
Verify 240VAC power is disconnected from the RV. Failure to obey this warning
could result in death or serious injury.
WARNING!
Electrical Shock Hazard:
Provide grounding in compliance with all applicable electrical codes. Failure to obey
this warning could result in death or serious injury.
