CT100G Series Inverter
CHAPTER 4 FUNCTION PARAMETER TABLE
- 30 -
CHAPTER 4 FUNCTION PARAMETER TABLE
CT100G series inverters have 16 groups of function codes F00
～
F15 and factory
group F16. The function codes have been divided into three levels. For example,
“F08.08” means the eighth function code in the P8 function group. F15 group is
factory group, and users are forbidden to access these parameters.
For the convenience of function codes setting, the function group number
corresponds to the first level menu, the function code corresponds to the second
level menu and the function code parameter corresponds to the third level menu.
1. Below are the instructions of the tables for function codes:
The first line “Function code”: codes of function parameter group and parameters
The second line “Name”: full name of function parameters
The third line “Detailed instruction of parameters”: Detailed illustration of the
function parameters
The forth line “Default value”: the original factory set value of the function
parameters
The fifth line “Modify”: the modifying character of function codes (the parameters
can be modified or not and the modifying conditions), below are the instructions:
“○”: means the set value of the parameter can be modified in stop and running
state
；
“
☆
”: means the set value of the parameter cannot be modified in running state
；
“●”: means the value of the parameter is the real detection value which cannot be
modified.
(The inverter has limited the automatic inspection of the modifying character of
the parameters to help users avoid modifying by mistake)
The sixth line “No.”: the serial number of the function parameters
2. “Parameter radix” is decimal (DEC), if the parameter is expressed by hex, then
the parameter is separated from each other when editing. The setting range of
certain bits are hex (0
～
F).
3. “Default value” means the function parameter will restore to the default value
during default parameters restoring. But the detected parameter or recorded
value will not be restored.
4. For a better parameter protection, the inverter provides password protection to
the parameters and only factory and administrator can modify the function codes.
After setting the user password (F05.03 is non-zero) and press the ESC key to
enter into the parameter editing state, the system goes into user password
verification and displays “0. 0. 0. 0. 0.”. You can enter only by inputting the
correct user password. For the factory setting parameter zone, only factory can
enter. (Remind that the users cannot modify the factory parameters by
themselves; otherwise, if the parameter setting is incorrect, damage to the
system may occur). If the password protection is unlocked, the user can modify
the password freely and the user password will be subject to the last one. When
F05.03=0, the user password is disabled.
5. When modifying the function parameters through 485 communication, the
function of user password follows the above rules.
Table 4-1 Parameter table
Functio
n code
Name
Detailed instruction of parameters
Default
value
Attrib
ution
F00 Group Basic function
