80
80
3.8
Activation of remote control
As long as the remote control is placed on the charger(control contacts closed on BI 5910) the
radio controlled safety module work only with its hard wired safety sensors.. When the remote
control is taken from the charger the control contacts open and indicate to the BI 5910 that the
remote control is now on operation. If the safety contacts are already active the BI 5910 waits
for the period of time adjusted with the rotational switches that the radio transmission get
active. This state is indicated by the fast flashing white LED run2 and status output 58. Within
this time the activation of the remote control must take place or it must be placed back on the
charger. If this is not the case the safety relays will be de-energised.
Activation procedure of the remote control:
1. insert the electronic key
2. release of the e-stop butto
3. activate green start button (for max 3 seconds)
To stop the remote control
press e-stop.
Notes:
If this procedure is not followed, the remote control goes into failure mode with flash
code: 5 pulses of red and green LED.
3.8
Activation of remote control
As long as the remote control is placed on the charger(control contacts closed on BI 5910) the
radio controlled safety module work only with its hard wired safety sensors.. When the remote
control is taken from the charger the control contacts open and indicate to the BI 5910 that the
remote control is now on operation. If the safety contacts are already active the BI 5910 waits
for the period of time adjusted with the rotational switches that the radio transmission get
active. This state is indicated by the fast flashing white LED run2 and status output 58. Within
this time the activation of the remote control must take place or it must be placed back on the
charger. If this is not the case the safety relays will be de-energised.
Activation procedure of the remote control:
1. insert the electronic key
2. release of the e-stop butto
3. activate green start button (for max 3 seconds)
To stop the remote control
press e-stop.
Notes:
If this procedure is not followed, the remote control goes into failure mode with flash
code: 5 pulses of red and green LED.
Summary of Contents for BI 5910
Page 129: ...129 129 Appendix Appendix...