Dodge Durango 2015, Operating Information Manual

Page: 238 / 738

the selected position have been met. To
retry a shift: return the control knob back
to the original position, make certain all
shift requirements have been met, wait
five seconds and try the shift again.
•
If all the requirements to select a new
transfer case position have been met, the
current position indicator light will turn
OFF, the selected position indicator light
will flash until the transfer case com-
pletes the shift. When the shift is com-
plete, the position indicator light for the
selected position will stop flashing and
remain ON.
AWD Auto To Low Range
NOTE:
When shifting into or out of LOW RANGE
some gear noise may be heard. This noise is
normal and is not detrimental to the vehicle
or occupants.
Shifting can be performed with the vehicle roll-
ing 2 to 3 mph (3 to 5 km/h) or completely
stopped. Use either of the following procedures:
Preferred Procedure
1. With the engine running, slow the vehicle to
2 to 3 mph (3 to 5 km/h).
2. Shift the transmission into NEUTRAL.
3. While still rolling, rotate the AWD control
switch to the desired position.
4. After the desired position indicator light is
ON (not flashing), shift the transmission
back into gear.
Alternate Procedure
1. Bring the vehicle to complete stop.
2. With the ignition switch in ON/ RUN position
and engine running, shift the transmission to
Neutral.
3. Rotate the AWD control switch to the desired
position.
4. After the desired position indicator light is
ON (not flashing), shift the transmission
back into gear.
NOTE:
•
If Steps 1 or 2 of either the Preferred or
Alternate Procedure are not satisfied
prior to attempting the shift or if they no
longer are being met while the shift at-
tempt is in process, the desired position
indicator light will flash continuously
while the original position indicator light
is ON, until all requirements have been
met.
•
The ignition switch must be in the RUN
position for a shift to take place and for
the position indicator lights to be oper-
able. If the ignition switch is not in the
RUN position, then the shift will not take
place and no position indicator lights will
be on or flashing.
235