Dodge Durango 2015, Operating Information Manual

Page: 96 / 738

Memory Position Recall
NOTE:
The vehicle must be in PARK to recall
memory positions. If a recall is attempted
when the vehicle is not in PARK, a message
will be displayed in the Driver Information
Display (DID).
Driver One Memory Position Recall
•
To recall the memory settings for driver one
using the memory switch, press MEMORY
button number 1 on the memory switch.
•
To recall the memory settings for driver one
using the RKE transmitter, press the UN-
LOCK button on the RKE transmitter linked
to memory position 1.
Driver Two Memory Position Recall
•
To recall the memory setting for driver two
using the memory switch, press MEMORY
button number 2 on the memory switch.
•
To recall the memory settings for driver two
using the RKE transmitter, press the UN-
LOCK button on the RKE transmitter linked
to memory position 2.
A recall can be cancelled by pressing any of the
MEMORY buttons during a recall (S, 1, or 2).
When a recall is cancelled, the driver’s seat,
and the power pedals (if equipped) stop mov-
ing. A delay of one second will occur before
another recall can be selected.
Easy Entry/Exit Seat
This feature provides automatic driver seat po-
sitioning to enhance driver mobility when enter-
ing and exiting the vehicle.
The distance the driver seat moves depends on
where you have the driver seat positioned when
you remove the Key Fob from the ignition (or
change the ignition to OFF, for vehicles
equipped with Keyless Enter-N-Go™).
•
When you remove the Key Fob from the
ignition (or change the ignition to OFF, for
vehicles equipped with Keyless Enter-N-
Go™), the driver seat will move about 2.4 in
(60 mm) rearward if the driver seat position is
greater than or equal to 2.7 in (67.7 mm)
forward of the rear stop. The seat will return
to its previously set position when you place
the ignition into the ACC or RUN position.
•
When you remove the Key Fob from the
ignition (or change the ignition to OFF, for
vehicles equipped with Keyless Enter-N-
Go™), the driver seat will move to a position
0.3 in (7.7 mm) forward of the rear stop if the
driver seat position is between 0.9 in and
2.7 in (22.7 mm and 67.7 mm) forward of the
rear stop. The seat will return to its previously
set position when you place the ignition to the
ACC or RUN position.
•
The Easy Entry/Easy Exit feature is disabled
when the driver seat position is less than
0.9 in (22.7 mm) forward of the rear stop. At
this position, there is no benefit to the driver
by moving the seat for Easy Exit or Easy
Entry.
Each stored memory setting will have an asso-
ciated Easy Entry and Easy Exit position.
93