Dodge Durango 2015, Operating Information Manual

Page: 189 / 738

mirrors will move back to their previous position
when the transmission is shifted out of RE-
VERSE. To make your selection, press the “Tilt
Side Mirrors In Reverse” button on the touch-
screen, until a check-mark appears next to
setting, indicating that the setting had been
selected. Press the back arrow button on the
touchscreen to return to the previous menu.
•
Blind Spot Alert
When this feature is selected, the Blind Spot
Alert feature Provides alerts, visual and/or au-
dible, to indicate objects in your blind spot. The
Blind Spot Alert feature can be activated in
“Lights” mode. When this mode is selected, the
Blind Spot Monitor (BSM) system is activated
and will only show a visual alert in the exterior
mirrors. When “Lights & Chime” mode is acti-
vated, the Blind Spot Monitor (BSM) will show a
visual alert in the exterior mirrors as well as an
audible alert when the turn signal is on. When
“Off” is selected, the Blind Spot Monitor (BSM)
system is deactivated. To change the Blind Spot
Alert status, press the “Off,” “Lights” or “Lights &
Chime” button on the touchscreen. Then press
the back arrow button on the touchscreen.
NOTE:
If your vehicle has experienced any damage
in the area where the sensor is located, even
if the fascia is not damaged, the sensor may
have become misaligned. Take your vehicle
to an authorized dealer to verify sensor
alignment. Having a sensor that is mis-
aligned will result in the BSM not operating
to specification.
•
ParkView® Backup Camera Active
Guidelines
Your vehicle may be equipped with the
ParkView® Rear Back Up Camera Active
Guidelines that allows you to see active guide-
lines over the ParkView Back up camera display
whenever the shift lever is put into REVERSE.
The image will be displayed on the radio touch-
screen display along with a caution note to
“check entire surroundings” across the top of
the screen. After five seconds, this note will
disappear. To make your selection, press the
“ParkView Backup Camera Active Guidelines”
button on the touchscreen, until a check-mark
appears next to setting, indicating that the set-
ting had been selected. Press the back arrow
button on the touchscreen to return to the
previous menu.
•
ParkView® Backup Camera Delay
When the vehicle is shifted out of REVERSE
(with camera delay turned OFF), the rear cam-
era mode is exited and the navigation or audio
screen appears again. When the vehicle is
shifted out of REVERSE (with camera delay
turned ON), the rear view image with dynamic
grid lines will be displayed for up to 10 seconds
after shifting out of “REVERSE” unless the
forward
vehicle speed exceeds 8 mph
(12 km/h), the transmission is shifted into
“PARK” or the ignition is switched to the OFF
position. To set the ParkView® Backup Camera
Delay press the “Controls” button on the touch-
screen, the “settings” button on the touch-
screen, then the “Safety & Driving Assistance”
button on the touchscreen. Press the “Parkview
Backup camera Delay” button on the touch-
screen to turn the ParkView® Delay ON or OFF.
186