Dobot MOOZ-2 PLUS, Operation Instructions Manual

Page: 8 / 30

5
2.2 Set the Zero Point
Zero point is the start point for the machine to print, which requires to be set only for the first use.Operation steps:
A4 paper
Heated bed
File Misc
Calibrate Tool
校准
自动 手动 零点
校准
Auto Level Manual Level Zero Setting
0 mm
Zeroing
Y: 20 X: 20 Z: 20
Fine Tune:
1 mm 0.06 mm 10 mm
Home Home
0 mm
Zeroing
Y: 20 X: 20 Z: 20
Fine Tune:
1 mm 0.06 mm 10 mm
Home Home
0 mm
Zeroing
Y: 20 X: 20 Z: 20
Fine Tune:
1 mm 0.06 mm 10 mm
Home Home
0 mm
Zeroing
Y: 20 X: 20 Z: 20
Fine Tune:
1 mm 0.06 mm 10 mm
Home Home
Press the “ -Z ” button to get the
nozzle closer to the heated bed, and
move the A4 paper back and forth at
the same time. Stop just when the
paper can slip with slight friction
Place a piece of A4 paper
on the heated bed
Press the “ ” button to record the
position of zero point. The machine
will home again after successful
recording
Press the “ Entrance to
control tools interface ” button
Press the “ Entrance to zero point
setting interface ” button
Fine tuning:
This function allows users to fine tune the zero of Z-axis according to bonding status of the first layer, in case the zero point is not satisfactory
after standard setting procedures. For instance, if the zero point is too high and causing bonding failure of the first layer:
Note:
1. For the 3D printing function, only the zero of Z-axis need to be set and recorded. Zeros of X-axis
and Y-axis are system default values and will not and cannot be changed.
5. If your printer prints in the mid air, the zero point must be wrongly set. After correct zeroing and
homing, the coordinate of Z should be about 190.
6. Please be prudent with the “ ” button, pressing it will change zero point of the
machine. If the fine tuning value remains 0, the operation will record current height of the nozzle
as zero point. If the fine tuning value is not 0, the operation will update zero point of Z-axis using
fine tuning value you set.
4. The zero point will not be lost after power-off, so there’s no need to reset it. However, the zero
point may be deviated and needs to be reset after the machine is reassembled or the functional
module is switched.
2. Too high Z-axis zero position will lead to loose bonding at the bottom, causing the model falling
off, and too low position will make it difficult to take off the model or even scratch the heated bed.
Dedicated fine tuning is always required to obtain satisfactory first several layers. If the zero
point is too high, please use a negative fine tuning value and use a positive fine tuning value if
the zero point is too low.
3. Pay attention when moving the head downward, especially when the nozzle is getting too close
to the bed. Even though the height detect protection will take effect and force the machine to go
0.06mm each press, the heated bed may also get burnt if you continuously move it downward
without testing the height with a piece of paper.
Press the “ ” button to fine tune the
zero point with the value you set. The machine
will home again after successful updating
Press “ - ” button to set a
negative fine tuning value