Dobot MOOZ-2 PLUS, Operation Instructions Manual

Page: 17 / 30

14
0 mm
Zero Setting
Y: 20 X: 20 Z: 20
Fine Tune:
1 mm 0.06 mm 10 mm
Home Home
0 mm
Zero Setting
Y: 20 X: 20 Z: 20
Fine Tune:
1 mm 0.06 mm 10 mm
Home Home
0 mm
Zero Setting
Y: 20 X: 20 Z: 20
Fine Tune:
1 mm 0.06 mm 10 mm
Home Home
Press the “ Zero point updating ” button
to record the position of zero point. The
machine will home again after successful
recording
Wear the googles to control the Z-axis to focus the laser
beam (until the spot is the minimum which should be judged by
naked eyes)
.
Switch the step distance to 1mm for fine tuning
Adjust the X-axis and Y-axis to move
the laser spot to desired position,
generally intersection at the lower left
corner of the workpiece
Note: 1. For the laser engraving function, the zeros of X, Y and Z axes shall all be set.
2. Zero point will not be lost after power-off, so there’s no need to reset it. However, the zeros may be deviated and needs to be reset after the machine
is reassembled or the functional module is switched.
3. If the position or size of the workpiece changes, it is necessary to refocus and set the zero point.
Warning: Make sure that the cables are plugged in place before power-on! Hot-plug will cause malfunction!
4. The laser unit is featured with focus length of 5~10mm, so it may not need to switch to 0.1mm step distance for focusing.