Dobot MOOZ-2 PLUS, Operation Instructions Manual

Page: 20 / 30

17
4.2 Install the CNC Bit
4.3 Set the Zero Point
Zero point
Operation steps:
①
Rotate counterclockwise to expand
the chuck with the wrench
②
Insert the CNC bit into
the chuck as far as you can
③
Rotate clockwise to clamp the CNC bit
Operation steps: Similar to laser engraving (Refer to Section 3.2 for details on setting the zero point)
Warning: When setting the zero point, use a small step distance in the end (0.1 / 1mm) so that the CNC bit does not accidentally hit the workpiece.
Note: 1. Keep the tool tip just or about to touch the upper surface of the workpiece in case of setting Z-axis zero point.
2. The current fixing method may damage the surface of the workpiece, and the user may place a block between the hex screws and the workpiece as needed
to compress the workpiece, provided that the block shall not interfere movement of the tool.
3. CNC chuck is easy to get rusty for long-time exposure to moisture. Please regularly apply anti-rust oil. In case of not in use for a long time, please remove
the entire module and wrap it with plastic bag!
4. The linear actuators contain precision components, please be sure to install the dustproof gasket to prevent intrusion of flying chips.
5. The machine may produce disturbing noise during working, you may leave it somewhere away from people and wait the work to be done.
6. Always use vacuum cleaner to remove the produced sawdust, blowing it away will contaminate the linear actuators and affect service life of the machine!
7. Please decide whether there is collision risk between the tool and CNC clamps according to the size of workpiece and pattern you about to carve, elevate the
workpiece with block, or put plastic spacer between the workpiece and clamp if necessary.