DNP CL-500, Service Manual

Page: 31 / 60

27
SET UP GUIDE
Adhesive evaluation
Adhesive evaluation
End
CONVEX
CONVEX
Yes
No
Adhesive is enough?
Raise the Heat roller temperature, or
lowered the laminate speed.
Yes
Card is warp?
4. Card Adhesiveness
3. (2) User Mode settings
3. (2) User Mode settings
3. (2) User Mode settings
No
End
Yes
Card is warp?
No
Both sides print by CX-320, Bend Remedy set OFF.
(After set OFF, leaves it about an hour.)
Using 1mil Patch, CX-320 Bend Remedy set OFF.
(After set OFF, leaves it about an hour.)
Single side print by CX-320, Bend Remedy set
On. (Only 0.6mil Patch and Overlay film)
The optimal value is set by combining the
Card Fan setting and Bend Remedy
setting on the CX-320
Cooling Time: 5 to 10sec
Decrease the Heat roller temperature then
Go to
Card Fan: lncrease the Card Fan wind.
Off
→
Low
→
Half
→
High
→
Full
3. (2) User Mode settings
Card Fan: Decrease the Card Fan wind.
Full
→ High → Half → Low → Off
3. (2) User Mode settings
Cooling Time: 5 to 10sec
In the case of single side print and CX-320 Bend
Remedy set ON.
(Only 0.6mil Patch and Overlay film)
If laminated surface is convex
The items in the broad outline are
common tuning for CX-320 and
CX-120.
CONCAVE
CONCAVE
If laminated surface is concave
3. (4) Printer (CX-320) Settings
3. (4) Printer (CX-320) Settings
3. (4) Printer (CX-320) Settings
3. (4) Printer (CX-320) Settings
2. SETTING PROCESS
We will recommend the condition setting to be tested after about 20 minutes have passed since it started. [There is no
Bend Remedy function of the card in CX-120 (CX-1** series).]
<NOTE> CX-320 including CX210, CX-320 and CX-3** series.
CX-120 including CX-120 and CX-1** series.