DNP CL-500, Service Manual

Page: 10 / 60

6
REMOVING MAIN PARTS
1. REPLACING HEATER
1) Remove two screws
Å
and remove the protective
sheet.
2) Remove one screw
ı
, shift the connect base a little
and remove the hook on the inner right hand side to
remove the halogen lamp.
Important : Do not remove screw
Ç
as this will break
the contact point of the heater.
3) Pull the halogen heater out to the front, replace it
with a new halogen heater and attach the screws in
the reverse order.
Important : Do not touch the glass section of the halo-
gen heater. Oil secretion from your hand
may reduce the lamp life.
2. REMOVING EXTERNAL PARTS
AND WIRING REFERENCE
DIAGRAM
2.1 REMOVING COVER
1) Remove six screws
Å
and remove the top cover
!
.
2) Pull the fan cable from the main board and remove
screw
ı
and the rear panel.
2.2 REMOVING FRONT PANEL
1) Remove cassette
5
and remove four screws
Å
.
2) Remove the front panel
4
slightly and pull the con-
nector on the front board.
REMOVING MAIN PARTS
Protective sheet
A
Connect
base
Screw
B Screw
C
Screw
(Do not remove)
A Screw
CN2
Fan cable
Rear panel
QYSDSP
4008N
B
A
QYSDSP4008N
x6
11
A
QYSDSP3006Nx4
5
4
Insert to FRONT
board CN02
Inset Diagram 1
Important
• Screws should be tightened.
• Do not wedge the wire into sharp edges.
Insert to shaft
Insert the claws on both sides of the
front panel to the plate and fasten
with screws.
Inset Diagram 1
Inset Diagram 2
Inset Diagram 2
(TFS0126)
(TFS0125)
Connector
CN02