DNP CL-500, Service Manual

Page: 30 / 60

26
SET UP GUIDE
(2) Example of Settings
The recommendation setting values when connects with CX-320 (CX210 and CX3** series) and CX-120 (CX-1**
series), and performing single side printing of a PVC card is shown below. CX-320 (CX210 and CX3** series) and CX-
120 (CX-1** series) are changed in the service mode.
Notes : The PVC card has various kinds and optimal conditions differ, respectively. In order to pull out the
performance of the Laminator to its maximum, please set it up after finding the best setting values.
Connect with CX-320 (CX210 and CX-3** series)
In case of CX-320 (CX210 and CX-3** series), the cards are heated in the printer previous to lamination, so it is
important to adjust the setting of the printer in the optimum condition.
Film 1mil 0.6mil overlay
Surrounding temperature 15 – 25°C 26 – 30°C 15 – 30°C 15 – 30°C
CL-500 Temp 170°C 155°C 130°C
Speed 5.5mm/s 8.5mm/s 8.5mm/s
Card fan Half High Off Off
Cool Time 0sec 0sec 5sec
CX-320 Retransfer Temp +1
(CX210 and Speed +2
CX-3** Bend Temp OFF OFF -2 -2
series) Remedy Speed +2 +2 -2 0
Cool 0sec 0sec 0sec 0sec
Connect with CX-120 (CX-1** series)
There is no Bend Remedy function in CX-120 and CX-1** series. Therefore, the optimum conditions are set up in the
combination of the setting item of Laminator. The example of a setup where adhesiveness was thought as important is
shown in the following.
Film 1mil 0.6mil overlay
Surrounding temperature 15 – 25°C 26 – 30°C 15 – 30°C 15 – 30°C
CL-500 Temp 175°C 150°C 130°C
Speed 7.0mm/s 7.5mm/s 8.5mm/s
Card fan Half High Off Off
Cool Time 0sec 0sec 5sec