DKT A/S
Fanoevej 6
DK-4060 Kirke Saaby
Tlf
Fax
E-mail
Web
+45 4646 2626
+45 4646 2625
www.dktcomega.com
Network Managed Optical Amplifier
User’s Manual Rev 1.3
OFA-CCS/CCD Series
June 2014
31
5.1.2
Network Configuration
User needs to set up network configuration for the product.
Factory default IP address is 192.168.0.100. Network configuration is to be modified by
either SNMP or Telnet. The modified configuration is enacted by reboot. The reset
command of CLI also allows the modified configuration to be enacted.
If information on modified configuration is forgotten, then use the console to check or reset
IP address. Note that network configuration can be set only by ADMIN account.
Factory Default
Item
Default Value
IP
192.168.0.100
SubnetMask
255.255.255.0
Gateway
192.168.0.1
5.1.3
SNMP Configuration
This unit supports SNMPv1, SNMPv2, and SNMPv2c. SNMPv3 will not be supported
until next software upgrades. Using MIB Table for SNMP interface, GUI (Graphic User
Interface) can be established for remote control and monitoring.
Read Only Community: Accounts for general users like operators who are not allowed to
modify configurations. Identical to USER account in CLI.
Read/Write Community: Accounts for system administrators, who can modify product
configurations. Identical to ADMIN in CLI
Trap IP: IP address for Trap Receiver which receives alarm information in an event of
alarm activation. Up to 5 Trap IP can be assigned.
Trap Enable: Enable alarm transmission to Trap IP. Assign Trap IP before Trap Enable
Trap Community: The community name to be used by the device when sending traps.
Factory Default
Item
sub-command
Default Value
RO community
ROCOMM
PUBLIC
RW community
RWCOMM
PRIVATE
Trap IP
TRAP
0.0.0.0
Trap Enable
TRAPEN
OFF
