DKS 1812 Plus, Installation & Owner'S Manual

Page: 19 / 58

1812-162-V-5-16 17
J1
1
2
3
4
5
6
7
8
J4
The 1812 Access Plus operates ONLY
on 16.5 VAC. DO NOT power the 1812
with 24 Volt transformer or source
voltage. Use the supplied power
transformer, 16.5 VAC, 20 VA (or UL
listed equivalent) to power the
telephone entry system. DO NOT power
any other devices (electric strikes,
magnetic locks, additional 1812s etc.)
from the 1812’s power transformer.
See page 13 for wire size and run
distances.
Homeowner’s Phone
LAN/Cordless
1.9 Wire One 1812 - Intercom Mode
LOW VOLTAGE LINE
OUT OUT
1878-010
IN IN GND GND
INPUT
OUTPUT
Phone
Jack
Cat5e
Ground 12 AWG Min.
Not
Used
Homeowner’s Phone
LAN/Cordless
Be sure to properly ground the 1812. See
page 13 for acceptable grounding sources.
Be sure to properly ground the
surge suppressor.
See page 13 for
acceptable grounding sources.
Low Voltage Surge Suppressor
DoorKing Surge Suppressor P/N 1878-010 (or
equivalent) is optional but highly recommended.
For best protection, surge suppressor ground wire
MUST be 3-ft. or less in length. Use minimum 12 AWG
wire. Refer to instruction sheet included with surge
board for complete information.
Connect to Homeowner’s Telephone
When connecting directly to a single telephone or an
un-used C.O. port on a PBX or KSU system, use the
PHONE OUT terminals only in the 1812. It must be
programmed for INTERCOM mode using this
configuration.
When the 1812 is programmed for intercom mode, it
provides the constant source of DC voltage necessary
for communication. The intercom mode also
disconnects the “PHONE IN” terminals (1 and 2)
since they are not used.
Be sure that the 1812 is programmed in the intercom
mode.
J1
Main
Terminal
TIP
RING
1970-010
Supplied Transformer
Polarity does not matter.
Output
16.5 V
AC
20 V
A
18
17
16
Com
15
N.C.
14
N.O.
13
Com
12
N.C.
11
N.O.
10
9
8
7
6
5
RING
4
TIP
3
GND
2
TIP
1
RING
16.5
VAC
Phone In
TIP (+):
White/blue mark
RING (-):
Blue/white mark
Telephone Line
For complete information,
see page 12.
Phone Out
Intercom Mode
Cordless Phone Base Station
Cordless
Option
RJ-11
Phone
Connector
Remote phones throughout house.
77 88 99
44 55 66
00
Older Lines
Green Wire (+)
Older Lines
Red Wire (-)
Single 1812 Wiring Configuration
Use minimum 18
AWG wire for runs
up to 100 feet.
16 AWG wire for
runs up to 200 feet.
(Term. 11 and 13)
“Normally Open”
Vehicular
Gate Operator
Access Control Devices
Maglock
Electric
Strike
WA
RNIN
G
MOV
ING
GA TE C
AN CA
US E
Op
era te g ate
onl y w he
n g ate ar ea i
s in sig ht
and f ree
of pe ople
and obs tru
ctio ns.
Do no t al
low ch ildr
en t o p lay
in gat e a
rea
or o
pe rate
gate .
Do
no t stan
d in gate pa
th o r w alk
thr oug h
path w
hile ga te is
m ovin g.
Rea d ow
ne r’s m
anu al a nd s
afe ty ins
tru ctio ns.
SERIOUS
IN
JURY
OR DE
ATH
CLA
SS
CERT
IFIE D TO
CA N/C
SA C2 2.2
NO . 2 47
CO NF
OR MS TO AN SI/U
L-3 25
VEHI
CUL AR
GA TE OPE
RA
TO R HP
533 82
MO
DE L
SER IAL
VO LTS
PH AS E
AM
PS
60 H z
MA
X G ATE LO
AD Doo rKin
g, In c.,
Ing lew ood
, C A
Magnetic locks or electric strikes must be
powered from a separate UL Listed power
transformer.
DO NOT power strikes or
magnetic locks from the 1812 power
transformer. Use minimum 18 AWG wire for
runs up to 100 feet; 16 AWG wire for runs
up to 200 feet. It is recommended to keep
power wire runs as short as possible.
Separate UL
Listed Power
Transformer
Phone Out
(4-5)
Pedestrian
Gate/Door
“Normally Close” with Maglock
(Terminal 15 and 16)
“Normally Open” with Electric Strike
(Terminal 14 and 16)
Recommended Recommended
Relay 1
(11-13)
Note: Each relay can control a
normally open
OR normally close
access control device. Relay
contacts are rated for 3 amps @
30 VAC maximum.
Relay 2
(14-16)
Power
(17-18)
OV
DO NOT wire the
wireless adapter to the
PHONE OUT main
terminal connection.
Please refer to the
“Wireless Adapter”
manual 1815-560 for
correct wiring.
Wireless Adapter