DKS 1812 Plus, Installation & Owner'S Manual

Page: 32 / 58

1812-162-V-5-16 30
2.4 System Parameters Programming
Follow these steps when programming the 1812 Access Plus from the Homeowner’s Touch-Tone
Telephone.
IMPORTANT The system will require an “ATTENTION NUMBER”. The system attention number is
the number that the 1812’s programming mode will respond to when called from the
Homeowner’s Phone . If more than one 1812 is sharing the phone line, be sure that each
system’s attention number is unique.
Note: The system attention number is
factory set to 7 . This can be changed to any number, and
will have to be changed when using multiple systems on the same phone line, see section 2.4.3.
77 88 99
44 55 66
00
Programming from the System Keypad
Programming from a Touch-Tone Telephone
Homeowner’s Touch-Tone Telephone
Follow these steps when programming the 1812 Access Plus from an Off-Site Touch-Tone
Telephone .
IMPORTANT The 1812 must be programmed to answer incoming calls, section 2.4.9.
Off-Site Touch-Tone Telephone
1. Press
*
and then the system ATTENTION NUMBER. [
*
7 (beep)]
2. Follow the programming instructions as described in each section of this manual. The system will
prompt you with short (beep) tones when programming steps have been followed correctly.
3. When complete, hang up. You cannot use 0# pressed together to end programming steps from a
touch-tone telephone. Wait 30 seconds before calling back to program another feature.
1. Call the resident telephone number. The 1812 will answer with a short beep after the programmed
number of rings.
2. Follow the programming instructions as described in each section of this manual. The system will
prompt you with short (beep) tones when programming steps have been followed correctly.
3. When complete, hang up. You cannot use 0# pressed together to end programming steps from a
touch-tone telephone. Wait 30 seconds before calling back to program another feature.
Follow the programming instructions as described in each section of this manual.
IMPORTANT The system will prompt you with short tones (beep) when programming steps have
been correctly keyed in and with a long tone (beeeeeep) when all of the programming steps have
been successfully completed in the sequence.
IMPORTANT! We strongly suggest that you read these programming instructions in their entirety
before beginning any manual programming of the 1812 Access Plus system.
The programming table on the next page provides a quick reference to: