![background image](http://html1.mh-extra.com/html/dish-network/167820/167820_user-manual_2509147027.webp)
15
6
Use the
ARROW
buttons to move the highlight to the TV1
remote address (the
Rem Addr
box as shown below). This is
important—if you do not move the highlight, your remote
changes the receiver's TV2 remote address (the
Rem Addr
box) and causes your Remote Control 1 to control the TV2 side of
your receiver.
7
Press the
RECORD
button on the green TV1 remote control you
are setting up. If you get a warning that tells you to pick another
address, continue on to the next step. If no warning appears, go to
step 15 of this procedure.
8
Select
OK
using the front panel button to clear the warning
message and return to the System Info screen.
9
On the remote control, press and hold the
SAT
mode button for
about three seconds, until all the mode buttons light up, and then
let go of the
SAT
button. The
SAT
mode button blinks.
10
Use the number buttons to enter any number from 1 to 16, except
for the address shown for
on your screen.
Write down the number you entered:
11
Press the
POUND
(
#
) button. If you entered the address correctly,
the
SAT
mode button flashes three times.
12
Highlight the
Rem Addr
using the
ARROW
buttons on the
front panel of the receiver.
13
Press
RECORD
.
14
Make sure the System Info screen shows
UHF
and that this
address matches the number you entered in step 10.
15
Using the remote, select
Done
to close the System Info screen. If
nothing happens, use the front panel buttons to highlight the
Rem Addr
.
Press
RECORD
, and then select
Done
.
h
i
Device
Rem Addr
TV Ch Out
3
5
T
UHF
i
Note
: Highlight the
Rem Addr
(the lighter area in the
graphic above) using the
ARROW
buttons on the remote.
Summary of Contents for 167820
