![background image](http://html1.mh-extra.com/html/dish-network/167820/167820_user-manual_2509147016.webp)
4
R
EMOVING
F
IXED
C
HANNEL
M
ODE
FOR
TV
AND
/
OR
VCR
1
Press and hold the
TV
or
VCR
mode button until all four mode
lights illuminate.
2
Press the
STAR
(*) key followed by two zeros (*00).
3
Press the
POUND
(#) key. The
TV
or
VCR
mode button flashes
three times.
P
ROGRAMMING
U
SING
E
QUIPMENT
C
ODE
T
ABLES
You can set up the remote to control other equipment using the
equipment code tables listed on page 16 and the modes as shown on
page 1. To control a receiver in
AUX
mode, see page 8.
Instructions
Additional Information
1
Turn the equipment on.
Use the equipment’s front panel
buttons or its remote control.
2
Find the brand name of the
equipment in the tables
starting on page 16.
If the brand isn’t listed, see
Scanning for Equipment Codes
on page 6.
3
Press and hold the mode
button until all the other
mode buttons light up, and
then let go of the button.
The mode button flashes.
For example, hold the
TV
mode
button for a TV until all of the
other mode buttons light. When
you let go,
TV
mode button
flashes.
4
For AUX mode only
. Press
0 for a second TV, or 1 for a
second VCR, or 2 for a
tuner, or amplifier.
This step is for programming
the kind of equipment that
should be programmed in
AUX
mode. If you’re not
programming in
AUX
mode,
skip to step 5.
5
Enter one of the three-digit
equipment codes from the
table using the number
buttons.
The three-digit equipment code
should be for the brand name of
your equipment that you found
in step 2.
Summary of Contents for 167820
