Dish Network 167820, User Manual

Page: 21 / 48

9
Note : If you aren’t sure how to access the System Info screen or
if there isn’t a
SYSTEM INFO
button on the front panel of your
receiver, check your receiver’s User Guide .
Write down the address shown:
2 Press and hold the AUX button until all the other mode buttons
light up, and then let go of the button. The
AUX
button flashes.
3 Press the 3 button.
4
Use the
NUMBER PAD
to enter the address you wrote in
step 1.
5
Press
POUND (#
). The
AUX
button blinks three times.
6 Press RECORD to make sure the address in the remote matches
the address on the receiver.
R
EADING
O
UT THE
R
EMOTE
C
ONTROL
C
ODES
These instructions explain how to check the remote control code you
put in the remote control when you set it up. Be sure to write them in
the spaces provided on the inside back cover.
Instructions Additional Information
1
Press and hold the mode
button for the equipment
you want the remote to
control. When all the other
mode buttons light up, let
go of the mode button—
that mode button should
now be flashing.
For example, hold the TV mode
button for a TV until all of the
other mode buttons light. When
you let go, the TV mode button
flashes.
2
Press the
POUND
(
#
)
button twice . The mode
button flashes the number
for each digit of the
equipment code, with a
pause between the groups
of flashes. A quick flash is
for zero.
For example, if the code is 570,
the mode button flashes five
times, pauses, flashes seven
times, pauses, and quick flashes
for zero.