B-13
Procedures to level the machine (Continued)
Step No.
Procedure
3
Raise (screw in) the sub-adjuster feet (2) at the bottom of the machine.
・
For leveling the machine, only the main adjuster feet are used (the sub-adjuster feet are
not used).
Sub-adjuster feet
Main adjuster
feet
4
Level the machine in right/left direction by adjusting the height of the adjuster feet while
checking the level gauge indication.
・
Check the level gauge indication to determine which adjuster foot is lower than the
others and raise that adjuster foot.
・
If the level gauge moves, accurate measurement results cannot be expected. Never
touch the level gauge until leveling of the machine completes.
5
Reposition the level gauge for front/rear leveling.
6
Level the machine in front/rear direction by adjusting the height of the adjuster feet while
checking the level gauge indication.
・
Check the level gauge indication to determine which adjuster foot is lower than the
others and raise that adjuster foot.
・
If the level gauge moves, accurate measurement results cannot be expected. Never
touch the level gauge until leveling of the machine completes.
7
If the gauge indications for both right/left leveling and front/rear leveling respectively
become 0.04mm/m or less, allow the machine to stand for 3 to 4 hours.
8
After 3 to 4 hours, recheck the level gauge indications to see if the machine is properly
leveled.
・
If the gauge indications are not within the acceptable range (0.04 mm/m or less), repeat
the steps 2 to 7 above for readjustment.
9
If the machine is properly leveled, withdraw the sub-adjuster feet until they touch the
floor.
・
Turn the sub-adjuster feet until they lightly touch the floor.
・
If the sub-adjuster feet are withdrawn too much to press the floor hard, the level gauge
indications may change.
10
Check to make sure that the level gauge indications for both right/left leveling and
front/rear leveling are 0.04 mm/m or less respectively.
・
If not, repeat the steps 2 to 7 above for readjustment.
11
Take out the level gauge from the machine.
Continued in the next section.
Summary of Contents for DAG810
Page 85: ......
