48
5 Use
5.2 Switching between power or silent mode
After starting, the robot cleans in power mode.
1.
Press the "
" key on the remote control
once to enable silent mode if necessary.
2.
Press the button again to switch back to
power mode.
5.3 Erecting a light fence
Proceed as follows to erect a light fence:
1.
Set the light fence tower in a place that
your robot will not pass (Fig. 19).
2.
Switch the light fence tower's power
switch to "On".
- The tower's LED is lit and then blinks.
- An
invisible
light fence is built up.
3.
Now power on the robot. It will not pass
the fence.
5.4 Erecting a smart fence
1.
Erect a light fence as described in
Z
Chapter 5.3, "Erecting a light fence"
.
2.
Press the "
" key on the remote control
to activate smart fence.
- A short beep occurs.
- An
invisible
smart fence is built up.
3.
Now power on the robot. Your robot will
completely clean the room it is in. Then it
will pass the light fence to clean the adja-
cent room.
24
HOUR
18
NOTE:
Once you have chosen the power mode,
the suction rate and working speed are
higher than in silent mode and therefore
your robot consumes more electricity.
19
24
HOUR
20
NOTE:
To deactivate the smart fence function,
press the "
" key again. You will hear
two short beeps.
Summary of Contents for M608 Navigator
Page 2: ...2 ...
