53
7 Troubleshooting
GB
7
Troubleshooting
7.1 If the appliance does not work as it should
See if you can solve the problem yourself by following the steps in the table below. If you cannot
solve the problem using this table, contact our Customers Service (
Z
Page 202, ‘International Ser-
vice’
) and describe the problem to us.
Problem
Possible cause / solution
The appliance will
not start.
The battery pack is not connected correctly.
Connect the battery pack correctly,
Z
Chapter 7.8, "Removing/replacing
the battery pack"
.
The battery pack is completely empty.
Switch off the appliance via the On/Off switch (position "0") and charge the
battery pack as described,
Z
Chapter 3.4, "Charging the battery pack for
the first time"
.
The toggle switch underneath the robot is not switched to "on" position
("0").
Switch the toggle switch to "on" position ("I"),
Z
Chapter 3.4, "Charging the
battery pack for the first time"
.
Perhaps you tried to start the appliance docked to the docking station and
charging. Wait until charging is completed.
Perhaps you tried to start the appliance via remote control but the battery
of the remote control is completely empty. Change this battery,
Z
Chapter
7.4, "Changing the side brush"
.
Red LED is blinking
fast while the blue
LED is lit constantly.
The capacity of the battery pack is too weak.
Your robot should dock onto the docking station by itself. If it does not - for
whatever reason - charge the battery pack as described,
Z
Chapter 3.4,
"Charging the battery pack for the first time"
.
Red and blue LED
blinking fast in com-
bination with 30 sec-
onds of short beep-
ing
The dust bin is not installed or not installed correctly.
Switch off your robot via the "On/Off" key (
) or the "
" key on the
remote control and insert dust bin module correctly,
Z
Chapter 6.2, "Emp-
tying the dust bin module"
.
Blue LED is lit and
red LED is blinking
fast in combination
with 2 long beeps
Drive wheel, side brush or main brush stuck.
Switch off your robot via the "On/Off" key (
) or the "
" key on the
remote control and remove dirt from wheels and brushes,
Z
Chapter 7.3,
"Removing and cleaning the main brush"
. If necessary, carefully use scis-
sors or tweezers.
Red LED is blinking
fast and blue LED is
blinking slowly in
combination with
2 long beeps
All 3 cliff sensors are triggered.
Move robot to an area without cliffs and restart.
Summary of Contents for M608 Navigator
Page 2: ...2 ...
