Dino lift Dino 180XT, Operation Instructions Manual

Page: 51 / 102

DINO 180XT
51
6. Inspecting the boom and the frame.
- Inspect the platform, its attachment, the lifting arms and the boom, with the telescope extended.
- Check boom joints and gliding surfaces and adjust if necessary. Lubricate the gliding surfaces.
- Check the condition of the Flyer-chain, fixations
and adjustment
- Check the fixation of the unloaded Flyer-chain to
the boom by pulling the Flyer-chain by hand when
the boom is in its maximum length.
- Inspect the turning device and its fixation and lubricate the bearing and turning gear ring. Remove
two half-moon shaped covers below the chassis to lubricate turning bearing nipples (4 pieces)
Warning! Using too high pressure when lubricating might press the turning bearing seal out of its
position.
- Measure play in the turning bearing, max. allowed axial play is about 1 mm (0,05").
- Measure the tightening torque of the mounting bolts:
280 Nm for M16
150 Nm for M12.
If you loosen or tighten screws and bolts, remember to put some locking liquid on them when
tightening. "Cross-tighten" the bolts.
- Inspect the chassis, and all welds. The turning system area and the outrigger attachment points
should be inspected with special care.
- Inspect the condition of the support outriggers.
- Inspect the tow bar and pay special attention to the bar - chassis attachment.
- Lubricate the boom and outrigger joint bearings.