Dino lift Dino 180XT, Operation Instructions Manual

Page: 23 / 102

DINO 180XT
23
3. Power connection
A. AC power
- Connect the mains cable (230VAC or 110VAC)
- Turn on the mains switch (fig. A)
- Voltage should be
- 230VAC (-10%/ +6%), frequency 50Hz, and mains fuse 16A
- 110V ± 15V, frequency 50Hz, and mains fuse 16A (GB)
- 110V ± 15V, frequency 60Hz, and mains fuse 16A (US)
when electric motor is loaded with max. load
(using a long cable may cause a voltage drop)
B. Interna combustion engine power (petrol/ gasoline aggregate)
- Do not connect the mains cable (230 VAC or 110 VAC)
- Turn on the mains switch (fig. A)
- Open the fuel cock
- Turn on the choke
Starting the engine when the battery is flat:
Press the push button located in the bed of the aggregate and pull the starter grip at the same
time.
Pull the starter grip lightly until you feel resistance, then pull briskly.
Caution! Do not allow the starter grip to snap back against the engine. Return it gently
to prevent damage to the starter.
- Adjust the motor running speed to middle position
Keep the aggregate running between movements too, because the battery will only be charged when
the aggregate is running.
Attention! The fuel cock must be closed when the lift is towed!
C. Internal combustion engine power (diesel aggregate)
- Do not connect the mains cable (230VAC or 110VAC)
- Turn on the mains switch (fig. A)
Starting the engine when the battery is flat ; follow the instructions on the separate diesel
engine manual.
Keep the aggregate running between movements too, because the battery will only be charged when
the aggregate is running.
Never turn off the mains switch when the diesel engine is running to avoid any damage to the
electrical equipment at the diesel engine.
4. Open the chassis control panel cover
Check that the battery voltage is adequate to make sure that the emergency descent system is in
working condition.
The charging level of the battery is indicated by two LEDs.
When charging the battery the red LED is on and the green one is off.
-
when the battery is charged to 80% , both LEDs are on
- when the battery is fully charged, the green LED is on and the red one blinks
- if both LEDs are on after full charging, the battery is dead.
5. Turn the operating switch (1) into position 1 (fig. B)