Dinli DL-702 2008, Service Manual

Page: 72 / 306

【
4-21
】
SUSPENSION/STEERING/DRIVE SHAFT
●
Remove the cage and boot from the front propeller shaft.
Inspection and Reassembly
●
Inspect the boots for wear or damage. If any damages are found,
replace them with new ones.
●
Inspect the axle play by using a push-and-pull motion given to
the axle shaft and wheel spindle, as shown.
●
Fit a boot on the propeller shaft end, fitting the small diameter
side of the boot to the shaft groove, fix its end with a new band
●
Install the cage [1] on the shaft.
[A] Large Diameter
[B] Small Diameter
NOTE
○
Wash the disassembled parts (except for the boots). After
washing, completely dry the parts using compressed air.
○
Clean the boots with a cloth.
CAUTION
○
Wash all parts before installation, clean the inside and outside
of the boots with a cloth.
○
Do not wash the boots in any commercially available
degreaser, such as gasoline or kerosene. Washing in a
degreaser causes deterioration of the boots.
CAUTION
Install the cage with the large diameter side facing the shaft
end.
CAUTION
Do not disassemble the wheel side joint (ball fixed joint). If any
damages are found, replace it with a new one.
1
B
A