38
9.4.
Powder Measure Conversion Procedure—Small to Large Bar—the Square Deal “B” ships with a small bar
First, loosen the Powder Measure Clamp, remove the Clip from the Failsafe Rod and pull the Rod out of the
Lock Link Assembly hole and slot. Lift the Powder measure up and off the Powder die and dump all the
powder out of the Powder Hopper, cycling the Powder Measure right side up and upside down.
Loosen the Pivot Screw and Self-Locking Locknut that attaches the Lock Link Assembly to the Powder
Measure just enough to disengage the Drive Pin from White Plastic Bell Crank “Cube” in the Powder Bar
slot.
Remove the Spacer Bar Retainer Plug and slide the Spacer Bar and Powder Bar and Spacer out of the
Powder Measure.
Slide Powder Bar out of the
Powder Measure
Self-locking
Locknut on
back of
Pivot Screw
Powder Bar
Drive Slot
Bell Crank White
Cube
Drive Pin
Bell Crank
Loosen the Pivot Screw and Self-
Locking Locknut on the back using
a 7/16” wrench and a 5/32” Allen
wrench.
Remove the Retainer Plug and Slide
the Powder Bar Spacer out
Remove the Powder
Measures Screw and
Clamp and lift the
Powder Measure up
off the Powder Die
Remove the Powder Measure
Failsafe Rod Spring Clip and
Failsafe Rod
Gently disengage the Drive Pin in the Bell
Crank and White Plastic “Cube” from the
slot in the Powder Bar
Summary of Contents for Square Deal B
