Digital Projection TITAN sx+-500, User Manual

Page: 56 / 120

Rev C March 2008 page 4.14
4. Controlling the projector Digital Projection
TITAN sx+-500
User Manual
Notes
The magnify feature utilises a
digital zoom. Used with the pan
control, this can be used to:
- enlarge a section of the image
- enable the use of multiple
projectors to construct a large
image from tiles.
The pan control is available only
when the image has been
magnified.
If the OSD moves off screen
due to a change in image size,
then pressing the size key will
restore its readability.
When fresh batteries are
inserted in the remote control it
will default to address 00.
Remote control 00 is a master
control, able to control all
projectors.
If two or more projectors are set
to the same address, they can
be controlled from a single
remote control, provided they
are connected by cable or are
both in range of the infra red.
Magnify and pan
•
Press Magnify MAGNIFY
followed by and to adjust the size of the picture.
•
Press Pan PAN
followed by , , and to adjust the position of the magnified image.
On-screen-display size
•
Press Size SIZE
to switch the size of the OSD between large and small.
Remote control address
The projector and the remote control need to be set to matching addresses. Read
the note to the right on this page, and follow the instructions in the order shown
below:
1 Set the projector address as shown in Setup menu , later in this section.
2 Set the remote control address:
•
Press and hold
whilst pressing two numbered keys 0 – 9
to set the remote control address to any number between 00 and 99
(leading zeros must be used for numbers less than 10) .
Remote control backlight
•
Press to switch the backlight on and off.