Digital Projection TITAN sx+-500, User Manual

Page: 42 / 120

Rev C March 2008 page 3.4
3. Getting started Digital Projection
TITAN sx+-500
User Manual
Adjusting the projected image
Picture settings
•
Press a key, followed by and to adjust these picture settings:
Brightness BRI
Contrast CON
Saturation SAT
Phase PHASE
Aspect ratio ASPECT
Geometry settings
•
Press Keystone KEYST
followed by and to adjust the keystone correction.
•
Press Position POS (for all inputs except DVI)
followed by , , and to adjust the picture position, for images
smaller than the DMD.
Switching the projector off
•
Press POWER on the remote control or keypad, and hold for 3 seconds,
to switch the projector OFF.
Notes
The Saturation control is
available for Composite, S-
Video and Component inputs
only.
The Phase control is available
for RGB inputs only.
For more detailed information
about:
- using the control keys on the
remote control or keypad,
- using the menus,
see the next section:
Controlling the projector.
For all adjustments that require
more than one key to be
pressed:
- after 10 seconds, if no
adjustment has been made, the
indicator will go out and the
adjustment key must be
pressed again.
- to end the adjustment before
10 seconds has elapsed, press
a different adjustment key, or
press the Exit key.
Always allow the lamp to cool
for 5 minutes before:
- disconnecting the power
- moving the projector
- changing the lamp