Digital Projection TITAN sx+-500, User Manual

Page: 52 / 120

Rev C March 2008 page 4.10
4. Controlling the projector Digital Projection
TITAN sx+-500
User Manual
Notes
Closing the shutter produces a
better black than simply
removing the signal, as the light
source will be completely
blocked by the shutter blade.
When the OSD is OFF:
- all menu navigation keys are
disabled.
- keys such as BRI
(brightness) will still function,
but the slider bars will not be
visible on screen.
When any of the three Lens
adjustment keys is pressed, the
blue Transmit indicator on the
remote control will light for 10
seconds:
- after 10 seconds, if no
adjustment has been made, the
indicator will go out and the
Lens adjustment key must be
pressed again to resume
adjustment.
- to end the adjustment before
10 seconds has elapsed, press
a different Lens adjustment key,
or press the key.
- all other adjustments will be
locked out until the Lens
adjustment is ended.
For more information about the
amount of lens shift available,
see Section 2. Installation.
Using the control keys
Power
•
Press POWER and hold for 3 seconds, to switch the projector ON.
•
Press POWER and hold for 3 seconds, to switch the projector into
STANDBY mode.
Shutter
•
Press SHUTTER to OPEN the shutter.
•
Press SHUTTER to CLOSE the shutter.
On-Screen-Display
•
Press OSD to switch the On-Screen-Display OFF.
This includes ALL menus, controls and on-screen messages.
•
Press OSD to switch the On-Screen-Display ON.
Focus
•
Press followed by and to adjust the focus.
When adjustment is finished, press .
Zoom
•
Press followed by and to adjust the zoom.
When adjustment is finished, press .
Shift
•
Press followed by , , or to shift the lens up, down, left or
right.
When adjustment is finished, press .