Page 4.30
Rev B September 2010
4. Controlling the projector
Digital Projection
TITAN 1080p 3D, Dual 3D. Ultra Contrast
User Manual
For important information about how Input 8 is used, see
INPUT 8
in the Notes column
, and also
Section 4, Overview
.
When Input Detection is set to Custom:
Press
and
to select one of the adjustment sliders.
Press
and
to adjust the slider to match the resolution of the incoming
video signal.
Blanking
Blanking curtains can be applied to each edge of the picture.
Press
and
to select Blanking.
Press
to open the Blanking submenu.
Blanking On/Off
Press
and
to select from:
On
Off
Blanking adjust
Press
and
to select the edge to be blanked.
Press
and
to adjust the slider (0 to 200).
•
•
•
•
Notes
None of the
Geometry
controls
are available for Input 8.
The adjustment sliders are
available only if Input Detection
is set to Custom.
Total H Samples
is available
for RGB1 and RGB2 inputs
only.
V Offset
is available for DVI
input only.
Geometry Menu
Blanking
The blanking curtains will not
applied until
Blanking
is turned
On
.
The
On Screen Display
will
move to the centre of the DMD
when
Blanking
is turned
On
.
Set to zero for no blanking, eg
the top edge in this example.
Geometry menu continued
