Page 4.16
Rev B September 2010
4. Controlling the projector
Digital Projection
TITAN 1080p 3D, Dual 3D. Ultra Contrast
User Manual
For important information about how Input 8 is used, see
INPUT 8
in the Notes column
, and also
Section 4, Overview
.
Notes
The magnify feature utilises a
digital zoom. Used with the pan
control, this can be used to:
- enlarge a section of the image
- enable the use of multiple
projectors to construct a large
image from tiles.
The pan control is available
only when the image has been
magnified.
The
Magnify and pan
controls
are NOT available for Input 8.
If the OSD moves off screen
due to a change in image size,
then pressing the size key will
restore its readability.
When fresh batteries are
inserted in the remote control
it will default to address
00
.
Remote control
00
is a
master
control, able to control all
projectors.
If two or more projectors are set
to the same address, they can
be controlled from one remote
control, provided they are
connected by cable or in range
of the infra red.
Magnify and pan
Press Magnify
MAGNIFY
followed by
and
to adjust the size of the picture.
Press Pan
PAN
followed by
,
,
and
to adjust the position of the magnified image.
On-screen-display size
Press OSD
OSD
to switch the size of the OSD between large and small.
Remote control address
The projector and the remote control need to be set to matching addresses. Read
the note to the right on this page, and follow the instructions in the order shown
below:
1
Set the projector address as shown in
Setup menu
, later in this section.
2
Set the remote control address:
Press and hold
whilst pressing two numbered keys
0 – 9
to set the remote control address to any number between 00 and 99.
(leading zeros must be used for numbers less than 10)
Remote control backlight
Press
to switch the backlight on and off.
•
•
•
•
•
