Page 2.14
Rev B September 2010
2. Installation
Digital Projection
TITAN 1080p 3D, Dual 3D. Ultra Contrast
User Manual
Notes
Be careful not to scratch
the lens surfaces. If you do
accidentally touch a lens, then
clean the surface using a lens
paper.
The lens release lever should
always be set to the locked
position to prevent the lens
from falling out.
Make sure the front lens cap is
removed, before switching on
the projector.
Lens clamp kit, part number
111-256, comprises:
2 x lens clamp quadrants
4 x 20mm M3 allen screws
Turn the lens release lever anti-clockwise so that it is pointing downwards, to
close the lock fully.
•
Lens release
lever, locked
Fixed lens clamp
In addition to the lens lock, any of the fixed lenses can be permanently secured to
the projector, as follows:
Fit and lock the lens to the projector, as described above.
Fit the two clamp quadrants either side of the lens, as shown below, and secure
them with the four screws.
•
•
Lens clamp
quadrants
