Page 4.28
Rev B September 2010
4. Controlling the projector
Digital Projection
TITAN 1080p 3D, Dual 3D. Ultra Contrast
User Manual
For important information about how Input 8 is used, see
INPUT 8
in the Notes column
, and also
Section 4, Overview
.
Notes
None of the
Geometry
controls
are available for Input 8.
horizontal and Vertical
Aspect Ratio
adjustments are
available only when
User
is
selected in
Aspect Ratio
, (see
previous page).
Keystone
adjustment can be
found in both the Geometry and
Projector Setup menus.
The range of adjustment will
be dependent on the input
resolution.
Phase
adjustment can be
found in both the Picture and
Geometry menus, and is
available for graphics based
RGB sources only.
user horizontal Aspect ratio
Press
and
to select User H Aspect.
Press
and
to adjust the slider (internal number – adjust to fit).
User Vertical Aspect Ratio
Press
and
to select User V Aspect.
Press
and
to adjust the slider (internal number – adjust to fit).
Keystone
Used to correct for distortion caused by the projector being mounted higher or lower
than the screen.
Press
and
to select Keystone.
Press
and
to adjust the slider.
Phase
Phase should be set automatically by the projector, but can be adjusted manually to
correct for shimmering or poor quality definition on, for example, fine text.
Press
and
to select Phase.
Press
and
to adjust the slider (0 to 32).
•
•
•
•
Geometry menu continued
