Digital Projection
E-Vision 6500 Series
Operating The Projector
Installation and Quick-Start Guide
10
Rev D July 2014
Operating The Projector
Switching the projector on
•
Connect the power cable between the mains supply and the projector. Switch on at the switch next to the power connector.
•
Wait until the self-test has completed and the
Power
indicator on the projector control panel shows amber. The lamp will be off and the
projector will be in
STANDBY
mode.
•
Press
on the control panel or
POWER ON
on the remote control.
The
Power
indicator on the control panel will flash green for a few seconds whilst the lamp comes up to full brightness. When the
projector is ready for use, the
Power
indicator will show steady green.
Selecting an input signal or test pattern
Input signal
•
Connect an image source to the projector. The signal should be automatically detected by the projector, and should be displayed within a
two or three seconds.
•
If more than one signal is connected, then select the image you want to display:
Press
SOURCE
on the control panel to cycle through the inputs,
or press
INPUT
on the remote control, then
or
to cycle through the inputs.
Test pattern
If you have no image source connected to the projector, then you can display a test pattern instead:
Press
TEST PATTERN
on the remote control, then
or
to cycle through the patterns,
or select a
Test Pattern
from the
Installation menu
.
Notes
Before switching on the projector
for the first time, make sure
the electric circuit is grounded.
Poor grounding may damage the
projector.
Always allow the lamp to cool for
5 minutes before:
- disconnecting the power
- moving the projector
For full details of how to connect an
image source to the projector, see
the
Connection Guide
.
For full details of how to use the
controls and the menu system, see
the
Operating Guide
.
