Digital Projection
E-Vision 6000 Series
OPERATING THE PROJECTOR
Installation and Quick-Start Guide
12
Rev D July 2014
Operating The Projector
Switching the projector on
1. Connect the power cable between the mains supply and the projector. Switch on at the switch next to the power connector.
The
Power
indicator on the projector control panel will show amber and the
Warning
indicator will show green. The lamp will be off and
the projector will be in
STANDBY
mode.
2. Press the
POWER
button on the control panel or on the remote control. The
Power
indicator on the control panel will flash green for a few
seconds whilst the lamp comes up to full brightness. When the projector is ready for use, the
Power
indicator will show steady green.
3. Select the default language.
Selecting an input signal
Connect an input source to the projector. The signal should be automatically detected by the projector, and should be displayed within
two or
three seconds.
If more than one signal is connected, then select the input you want to display:
1. On either the control panel or remote, press
MENU
.
2. From the list of available menus, select
INPUT
.
3. Use the
UP
and
DOWN
arrow buttons to navigate, then
ENTER
to select the input you wish to display. Press
MENU
to exit.
Notes
The language selection screen only
appears the first time you power on
the projector. For information about
changing the default language at
a later stage, see the
Operating
Guide
.
For full details of how to connect an
input source to the projector, see the
Connection Guide
.
For full details of how to use the
controls and the menu system, see
the
Operating Guide
.