Digital Identification Solutions XID 8300, Service Manual

Page: 32 / 56

1-32 (No.HD001<Rev.001>)
(4) Turn the take-up side using your hand until the broken por-
tion can no longer be seen.
• Align the film side of the unused portion with the arrow in-
dicated on the label of the cassette.
(5) Remove any slack in the film.
(6) Insert the cassette all the way in along the guide rail until
a “click” sound is heard, followed by closing the printer
door.
(7) Press [RESET]
→
to reset the printer.
5.1.9 MG Test Err A8
• A writing error has occurred during magnetic encoder self-di-
agnosis.
Press [RESET]
→
to reset the printer.
5.1.10 Ink Error B0
• An incorrect ink ribbon is installed.
Install a correct ink ribbon.
5.1.11 Ink Search B1
• Ink ribbon is broken.
Repair the ink ribbon.
(1) Open the printer door.
Memo:
• To avoid printing errors, it is recommended that you forward
by one or two images after installing the ink ribbon cassette
or retransfer film cassette.
Cautions:
• If the security lock is on, deactivate it. After work is com-
plete, activate the security lock again.
• Stand the cassette on a flat surface as illustrated in the di-
agram. Avoid doing so on the floor as dust attached to it
may cause printing errors.
• Do not touch the inked surface (the side that faces outward
when installed) with your hand. Touching it may cause
printing errors. Put on the supplied gloves when handling
the ink ribbon.
• The cassette is heavy when the ink ribbon is loaded. To
prevent the cassette from dropping during handling, make
sure to hold it with both hands.
• When installing a used ink ribbon, align the yellow side of
the unused ribbon with the arrow indicated on the label of
the cassette. If the position of the yellow side is not properly
aligned, the print may turn out light.
• Do not perform any work on the printer door. Do not place
heavy objects or apply load on the printer. Doing so may
damage it.
• During replacement, clean the four bobbin holders on the
printer. If burrs produced by friction with the bobbins are at-
tached to the bobbin holders, they may fall onto the card,
ink ribbon, or retransfer film, causing printing errors.
MG Test Err A8
Ink Error B0
Ink Serch B1