Digital Identification Solutions XID 8300, Service Manual

Page: 30 / 56

1-30 (No.HD001<Rev.001>)
5.1.7.2 If the card is inside the printer unit
• If the card is not drawn into the card feed roller and is left inside
the printer, use the tweezers (supplied) to remove the card.
(1) Turn off the power.
(2) Check the position of the card that is left inside the printer.
(3) Pick up the card using the tip of the card Pickup. (supplied)
• Be careful not to drop the card inside the printer.
(4) Pull out the card slowly.
(5) Install the retransfer film cassette, and close the printer
door.
(6) Turn on the power.
Go to step 5 of 5.1.7.
5.1.7.3 If the card is caught in the card feed roller to the
right of the retransfer heating roller
(1) Turn off the power, and detach the card hopper.
(2) Check the position of the card.
(3) Attach the jog dial to the card feed roller shaft and cleaning
roller shaft.
(4) Turn the card feed roller shaft and cleaning roller shaft in
the clockwise direction, while checking the position of the
card.
• Remove the card after it is discharged from the card load
slot.
(For single-sided printers, the card is discharged from
the NG card outlet.)
(5) Restore the jog dial to its original position, and install the
card hopper.
(6) Install the retransfer film cassette, and close the printer
door.
(7) Turn on the power.
Go to step 5 of 5.1.7.
Cautions:
• The card may be very hot. Be careful not to burn your fin-
gers when removing the card.
Memo:
Example of how to pick up the card
• Pick up the card by following the diagram above.