3–16
Removing and Replacing FRUs
3.2.5 Video Casting Assembly
Remove the video casting assembly as follows:
1. Remove the rear cover (Section 3.1.2).
2. Remove the top cover (Section 3.1.3).
3. Remove the interconnect cable (Section 3.2.1).
4. Remove the 2-wire, 3-pin cable (P4) from the connector (J4) at the top
of the video casting assembly (Figure 3–12) by pressing on the sides of
the connector and pulling. You may need a small screwdriver to assist
in releasing the tabs.
5. Disconnect the 6-wire, 8-pin brightness/contrast cable (P5) from the
connector (J5) at the bottom of the video casting assembly by pressing
the top center tab on the connector. Place the cable out of the way
behind the video casting.
