3–12
Removing and Replacing FRUs
3.2.4 Deflection Module
Remove the deflection module as follows:
CAUTION
Use a static protection kit (PN 29-26246-00) when handling the
deflection module.
1. Remove the rear cover (Section 3.1.2).
2. Remove the top cover (Section 3.1.3).
3. Remove the power supply module (Section 3.2.2).
4. Discharge the CRT and remove the anode cap (Section 3.2.3).
WARNING
You must complete the discharge procedure for the CRT
(Section 3.2.3) before removing the deflection module.
5. Remove the interconnect cable (Section 3.2.1).
6. Loosen the captive screw that holds the deflection module to the
chassis (Figure 3–9).
7. Remove the 2-wire, 3-pin G2 and Focus cable (P7) from the connector
(J7) at the top of the video casting assembly by pressing on the sides
of the connector and pulling. You may need a small screwdriver to
assist in releasing the tabs.
