Digital Equipment RouteAbout Access EW, Installation Manual

Page: 25 / 80

Installing the RouteAbout Access EW 2–5
Removing the Back Cover
If you are installing a module into a DEChub 90 or DEChub 900
MultiSwitch, remove the back cover as follows (refer to Figure 2-2).
Step Action
1 Lift up the latch on the back cover by inserting a flat-blade
screwdriver into the top mounting hole.
2 With the latch up, pull the top of the back cover away, pivoting
at the bottom of the module.
To install the module into a DEChub 90, go to the section titled
Installing the Module into a DEChub 90. To install the module into a
DEChub 900 MultiSwitch, go to the section titled Installing the Module
into a DEChub 900 MultiSwitch.
Figure 2-2 Removing the Back Cover