DVM-500 User’s Guide
Digital In-Car Video System
Digital Ally DVM User Guide Rev. F (334/1.6.2) Page
5
of
36
Wireless Microphone (RMT)
The Wireless Microphone (RMT) can be worn on a belt or other location.
The RMT contains a condenser mic built into the face of the unit. A lapel
mic can be attached to the input port located on the top of the RMT. The
RMT also features a large RECORD button that is used to remotely start
and stop a recording on the DVM.
Synching the Wireless Microphone (RMT) to the DVM
Prior to first use, the wireless microphone must be synchronized with
the Digital Video Mirror (DVM). Please note that the RMT must be
within 3 feet of the antenna during the synchronization process.
1.
Select Synch Wireless Microphone from the Main Menu.
2.
Select Wireless Mic #1 or #2
3.
Remove the Wireless Mic from the charging cradle.
4.
Hold down the Record button while turning it on until the Red,
Amber and Green LEDs begin to flash.
5.
Press the MENU Button on the DVM to begin searching for the
Wireless Mic.
Repeat the above procedure for Wireless Mic #2 if synching a second
RMT to the same DVM.
Power On/Off
The PWR (power) button toggles the RMT ON and OFF. To power
ON, press and hold the PWR button (located on the top of the RMT)
until the Green LED starts blinking. The LED will begin flashing every
3 seconds to indicate that it is powered ON and in Standby Mode. To
power OFF the RMT, press and hold the PWR button until the Green
LED lights steady and then turns off.
Start Transmitting Audio (Recording)
Transmit mode is entered by pressing and holding the RECORD button
on the RMT for a few seconds while it is in standby mode (Green LED
flashes periodically). The Red LED will begin flashing at 4 times per
second as it searches for the DVM unit on a clear channel. Release the
RECORD button, and if communication is established with the DVM,
the Red LED will be on steady. If the RMT is unable to establish
communication with the DVM in approximately 4-6 seconds, then it
will return to standby mode.
