AT commands
Location commands
Digi XBee® 3 802.15.4 RF Module User Guide
172
Default
0
PT (PWM Output Timeout)
Specifies how long both PWM outputs (
P0
,
P1
) output a given PWM signal before it reverts to the
configured value (
M0
/
M1
). If set to
0
, there is no timeout. This timeout only affects these pins when
they are configured as PWM output.
Parameter range
0 - 0xFF (x 100 ms)
Default
0xFF
Location commands
The following commands are user-defined parameters used to store the physical location of the
deployed device.
LX (Location X)
User-defined GPS latitude coordinates of the node that is displayed on Digi Remote Manager and
Network Assistant.
Parameter range
0 - 15 ASCII characters
Default
One ASCII space character (0x20)
LY (Location Y)
User-defined GPS longitude coordinates of the node that is displayed on Digi Remote Manager and
Network Assistant.
Parameter range
0 - 15 ASCII characters
Default
One ASCII space character (0x20)
LZ (Location Z)
User-defined GPS elevation of the node that is displayed on Digi Remote Manager and Network
Assistant.
Parameter range
0 - 15 ASCII characters
