3
3
Important notes
The BEETLE /M-III modular POS system corresponds to the relevant safety regulations pertaining to
data processing facilities.
NOTE
The device may be repaired only by authorized specialist staff. Improper repairs will lead
to the loss of any liability claims.
NOTE!
Sub-assemblies with ElectroStatic Discharge-sensitive components (ESD) can be marked
with this label.
When installing sub-assemblies or modules, please observe the following information that applies to all
sub-assemblies with ESD:
•
Ensure that the device is switched off and pull the power plug before you plug in, unplug or install
sub-assemblies.
•
Always use anti-static equipment (anti-static mat with ground cable with integrated leakage resis-
tance of 1 Mohm, anti-static armband with connection to the mat, anti-statically equipped tools). The
anti-static mat must be connected to a suitable ground point via the leakage resistance.
•
Place all sub-assemblies with ESD on a suitable anti-static base.
•
Touch sub-assemblies with ESD only at their edges and do not touch any components.
•
Do not touch any connector pins or conductor paths on an electrostatic-discharge-sensitive assem-
bly.
3.1
3.1
Safety Instructions
The BEETLE /M-III modular system corresponds to the relevant safety regulations pertaining to data pro-
cessing facilities.
•
If this device is moved from a cold environment into its operating room, condensation may occur. The
device must be absolutely dry prior to commissioning, therefore allow for an acclimatization time of at
least two hours before putting it into operation.
•
The device is equipped with a safety-tested power cable. It must be connected only to a properly
grounded contactor contact electrical socket.
•
When installing the device, please ensure that the device plug-in fixture and the contactor contact
electrical socket are easily accessible.
•
The device must be fully disconnected from the supply voltage when performing any work at the de-
vice and when plugging in or disengaging data cables. To completely disconnect the appliance from
the supply voltage, switch off the device and pull out the power plug of the power supply unit.
01750341829F
3-1
Summary of Contents for BEETLE/M-III
Page 16: ...Before switching on Press this forward so that the cable cover closes flat 01750341829F 6 5...
Page 34: ...Removing the housing cover Lift off the cover upwards Set it aside 01750341829F 12 2...
Page 45: ...Storage Media 01750341829F 13 11...
Page 61: ...Accumulator optional The UPS monitor opens 01750341829F 18 9...