Connecting orifice plate
9.2
9.2
System unit
The device must be fully disconnected from the supply voltage when performing any work at the device
and when plugging in or disengaging data cables. To completely disconnect the appliance from the
mains voltage, switch off the device and pull out the AC plug to the power supply unit. Peripherals may
not be plugged into the system when it is switched on!
Example of a connecting orifice plate:
1
3 x D-Sub (COM2*-COM4*- inter-
faces, with power supply or 5 x D-
Sub
2
Display 2 (DVI-D/PLINK2) with RMT for one Mx
and Rx Board,
without RMT with one Kx Board
3
1 x D-Sub (COM1 interface)
4
Display 1 (DVI-D/PLINK2) with RMT
5
15-pin Mini D-Sub socket (VGA)
6
Mini DIN (KYBD), keyboard
7
2 x USB-A (USB 2.0)
2 x USB-A (USB 3.0)
8
RJ socket (LAN)
9
3 x 3.5 mm jack bush (IN, Out,
Microphone)
10
3 x PoweredUSB 12 V (with a K1/K2, M1/M2 or
R1/R2-Motherboard)
01750341829F
9-3
Summary of Contents for BEETLE/M-III
Page 16: ...Before switching on Press this forward so that the cable cover closes flat 01750341829F 6 5...
Page 34: ...Removing the housing cover Lift off the cover upwards Set it aside 01750341829F 12 2...
Page 45: ...Storage Media 01750341829F 13 11...
Page 61: ...Accumulator optional The UPS monitor opens 01750341829F 18 9...
